2016 Series Finisher Display Assembly

You've run all five races and you've got your Series Finisher Medal Display now how do you put it together? We've put together a simply instructional post to help. 

STEP 1. UNPACK YOUR DISPLAY

We've inspected and wrapped every single display prior to packaging to ensure quality control. To open your display just untape and unwrap. 

STEP 2. INSTALL VELCRO DOTS

You'll notice 15 small Velcro dots taped to the pack of the display, remove those and flip the display over. To install the dots simply remove them, one at a time and place as shown in the images below. PRO TIP: Put both loop (soft) side on the board first for a firmer grip. 

When installing the loop (soft) side on the board stick the hook (spiky) side on. This will make is easier than installing anything on the medal itself. 

STEP 3. PREPARE YOUR MEDALS

Gather your race finisher's medals and undo the Velcro holding the ribbons together at the end then remove the ribbon from the medal. 

STEP 4. INSTALL MEDALS

Once the medals have been disassembled, press the medal on the designated spot on the board and firmly press down to secure the adhesive on the medal for the hook (spiky) side of the Velcro. When you've completed pressing firmly on the medal you can remove it from the board to ensure the dots have secured to the medal and are still secured to the board. 

The spots for each medal are: green = Sam Houston Race Park, orange = Minute Maid Park, yellow = Clear Lake, red = University of Houston, and blue = Sugar Land. 

STEP 5. INSTALL RIBBON

Once the medals are installed you are now ready to install the ribbons. Simply run the ribbon through the routed slot in the bottom of the board and connect the Velcro ends. 

STEP 6. HANG AND ENJOY YOUR ACCOMPLISHMENT!!!